1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Side Molding

Discussion in 'Exterior' started by carbonprizm, 2005年04月24日.

  1. Offline

    carbonprizm Guest

    Message Count:
    0
    ライク受信:
    0
    賞:
    0
    Side Molding

    I have a silver prizm and there is the black side molding on the doors and I was wondering if there was anyway to get rid of it. ONe of my friends said to get some fishing line and heat up one end with a blowdryer and then just strip it off slowly, does that work? Also what does it look like once its off are there any holes or markings from the molding. Thanks for your time
    carbonprizm, 2005年04月24日
    #1
  2. Offline

    alby13 New Member

    Message Count:
    1,003
    ライク受信:
    0
    賞:
    0
    blow dryer most likely will not create enough heat. try a heat gun for some serious work. just heat it up slowly and pull the molding off.

    i did mine with no heat gun and just fishing line along with "bug and tar remover."

    there were holes behind my moldings
    alby13, 2005年04月27日
    #2
  3. Offline

    azn_romeo Guest

    Message Count:
    0
    ライク受信:
    0
    賞:
    0
    sooo what did you do with your holes? like i mean what did u do to fill them in? i just did mine like an hour ago and put the mold back on the door, untill i find out what else do w/ the holes... lol haha im learning give me a break
    azn_romeo, 2005年05月28日
    #3
  4. Offline

    azn_romeo Guest

    Message Count:
    0
    ライク受信:
    0
    賞:
    0
    oh hey alby13 your ride is sweet, where'd you get the CAI?
    azn_romeo, 2005年05月28日
    #4

TRDの愛を広める