1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Broken Turnsignals

Discussion in 'Interior' started by Goldy, May 13, 2005.

  1. Offline

    Goldy Well-Known Member

    Administrator
    Message Count:
    32,006
    Likes Received:
    2,879
    Trophy Points:
    61,468
    Broken Turnsignals

    Ok, so I am about to wire up some LED M3 style mirrors, and I take out the bumperlights and drop one of the bulbs. To see if it still works, I put it back in and try the turnsignal. Nothing. I flip it the other way, nothing. I try the hazards, and they work. The lightbulb is fine (and so are the LED mirrors), but Now my turnsignals don't work. :confused: The bulbs and wiring is fine since the hazard function still works, and everything else in the car works, so I don't think that it is a fuse.

    What should I do to fix it? I don't want to drive around without turnsignals (or with my hazards on! :D )
    Goldy, May 13, 2005
    #1
  2. Offline

    AE102 New Member

    Message Count:
    2,569
    Likes Received:
    0
    Trophy Points:
    0
    its your fuse man. i did this before. pull out the negative battery cable before doin any electrical work.

    look in your engine bay and fine that turn signal fuse and replace it. i think its in your engine bay, not sure, might be under the dash.
    AE102, May 13, 2005
    #2
  3. Offline

    Goldy Well-Known Member

    Administrator
    Message Count:
    32,006
    Likes Received:
    2,879
    Trophy Points:
    61,468
    It was under the dash. All fixed :D
    Goldy, May 16, 2005
    #3
  4. Offline

    AE102 New Member

    Message Count:
    2,569
    Likes Received:
    0
    Trophy Points:
    0
    good :)
    AE102, May 16, 2005
    #4

Share This Page