installing aftermarket Tach?

installing aftermarket Tach?

does anyone on this board with a '93-97 Rolla installed a tach on their rides?
i just want to know how before getting one.

Search around on the forum. This topic has been covered in detail a couple times before. If you want to switch to a gauge cluster with tach, buy one and it should be as simple as switching the new cluster in if your car is a CE, DX or above model. If you have a base model, then you'll have to run a wire.

switching clusters is by far the easiest way to do it...

nah...i want those moster tachs that sits on the dash.
but i couldnt find any info on how to hook them up yet.

i tried installing a tach on the dash before i did a swap... they said you can tap a wire from the cluster for the signal... im not sure though... took me forever to do thats why i did a cluster swap...

word....so do you have teh wiring sheet that i can see?

There's a wiring diagram in the back of the haynes manual for the the instrument cluster. Don't think that's what you're looking for, but figured I'd mention it.

Actually, I'm sure there's a diagram for the distributor too, which I belive is where you would need to run the tach wire from.

this might help...

http://hp.autometer.com/instruction...instruction.pdf

shoot, the link is dead.

and yes, i want a diagram to the distributor, just the wires and color mess me up there.

i went to teh homepage and download the instrutions.
thanks all \(^_^)/