1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Side Molding

Discussion in 'Exterior' started by carbonprizm, Apr 24, 2005.

  1. Offline

    carbonprizm Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Side Molding

    I have a silver prizm and there is the black side molding on the doors and I was wondering if there was anyway to get rid of it. ONe of my friends said to get some fishing line and heat up one end with a blowdryer and then just strip it off slowly, does that work? Also what does it look like once its off are there any holes or markings from the molding. Thanks for your time
    carbonprizm, Apr 24, 2005
    #1
  2. Offline

    alby13 New Member

    Message Count:
    1,003
    Likes Received:
    0
    Trophy Points:
    0
    blow dryer most likely will not create enough heat. try a heat gun for some serious work. just heat it up slowly and pull the molding off.

    i did mine with no heat gun and just fishing line along with "bug and tar remover."

    there were holes behind my moldings
    alby13, Apr 27, 2005
    #2
  3. Offline

    azn_romeo Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    sooo what did you do with your holes? like i mean what did u do to fill them in? i just did mine like an hour ago and put the mold back on the door, untill i find out what else do w/ the holes... lol haha im learning give me a break
    azn_romeo, May 28, 2005
    #3
  4. Offline

    azn_romeo Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    oh hey alby13 your ride is sweet, where'd you get the CAI?
    azn_romeo, May 28, 2005
    #4

Share This Page